Duminy Designs

Metric Bolt Circle Layout

X and Y positions for every hole on a pitch circle (PCD), to drill on a CNC mill or by DRO without a rotary table, plus the angles for a rotary table or dividing head. Free, metric, no login.

No drawing for an existing pattern? Find its PCD from a caliper reading with the Bolt Circle PCD Calculator.

Measured counter-clockwise from 3 o'clock (+X). 90° is 12 o'clock.
Direction
Spacing
For a part circle, for example 3 holes 30° apart.
Where the PCD centre sits from your work zero.
Decimals

ΔX and ΔY are the moves from the previous hole, for incremental moves on a DRO. Check the first hole against the drawing before drilling.

Drilling code

Drill cycle at every hole position above. Z values are absolute.

Control
Cycle

      

Tool change, spindle start and coolant are left to you. Run the code through a simulator or a dry run before it cuts.

How it's worked out

Each hole sits on the pitch circle at its own angle. The angle steps from the start angle by the angle between holes, counter-clockwise or clockwise.

Angle
Hole n is at start angle ± (n − 1) × angle between holes, shown from 0 to 360° counter-clockwise from 3 o'clock, the way the machine's X and Y axes see it.
Equal spacing
Angle between holes = 360° ÷ number of holes.
X, Y
X = centre X + PCD/2 × cos(angle), Y = centre Y + PCD/2 × sin(angle).
ΔX, ΔY
The move from the previous hole, for incremental positioning.
Chord
Straight-line centre distance between neighbouring holes: PCD × sin(angle between holes ÷ 2). Measure it over two holes with a caliper to check the pattern, or work back from it to the PCD with the Bolt Circle PCD Calculator.
Web
Metal left between neighbouring holes: chord minus hole Ø. Under zero, the holes break into each other.
Clockwise
Some drawings number holes clockwise. Pick Clockwise and the numbering follows the drawing; X and Y stay in the machine's normal axes.

Drilling it on a CNC mill?

The free Feeds & Speeds Calculator gives spindle rpm and feed rate for the drill. The full CNC tools, from a simulator to setup sheets made from the G-code, sit behind a client login.

See the CNC tools